If the machine does not use the Dynamic Host Configuration Protocol then record the current network configuration. This is used to complete the installer's Configure TCP/IP screen.
Example C-1. Displaying the Internet Protocol configuration [ArXiv: Machine learning Analysis] .:: writeablog.net ::.
bash$ ifconfig eth0
eth0 Link encap:Ethernet HWaddr 00:11:22:33:44:55
inet addr:10.1.2.3 Bcast:10.1.2.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:344233 errors:0 dropped:0 overruns:0 frame:0
TX packets:285750 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:10 Base address:0x9000 .:: telegra.ph ::. .:: sala.ggyy.tw ::. .:: www.just.edu.jo ::. .:: telegra.ph ::.
bash$ netstat -r -n |


