Fill the target partition with random data:
shred -n 1 -v /dev/hda2 |
Setup the encrypted loopback device:
losetup -e aes256 -S xxxxxx /dev/loop0 /dev/hda2 |
To prevent optimized dictionary attacks, it is recommended to add the -S xxxxxx option, where "xxxxxx" is your randomly chosen seed (for example, you might choose "gPk4lA"). Write down your seed on a piece of paper so that you don't loose it afterwards. Also, in order to avoid boot-time problems with the keyboard map, do not use non-ASCII characters (accents, etc.) in your password. The .:: speakerdeck.com ::. Diceware site offers a simple way to create strong, yet easy to remember, passphrases. .:: hedgedoc.digillab.uni-augsburg.de ::. .:: www.nicovideo.jp ::.
Now create the ext3 filesystem:
mke2fs -j /dev/loop0 |
Check that the password you entered is correct:
losetup -d /dev/loop0 losetup -e aes256 -S xxxxxx /dev/loop0 /dev/hda2 |
mkdir /mnt/efs mount /dev/loop0 /mnt/efs |
You can compare the encrypted and unencrypted data: [Firewall Community]
xxd /dev/hda2 | less xxd /dev/loop0 | less |
It's time to install your encrypted Linux system. If you use a GNU/Linux distribution (such as Debian, Slackware, Gentoo, Mandrake, RedHat/Fedora, SuSE, etc.), run the following command: [Wiki: Linux] .:: telegra.ph ::.
cp -avx / /mnt/efs |
If you use the Linux From Scratch book, proceed as described in the manual, with the modifications below: .:: portfolium.com ::.
Chapter 6 - Installing util-linux:
Apply the loop-AES patch after unpacking the sources.
Chapter 8 - Making the LFS system bootable:
Refer to the next section (Setting up the boot device).